I’m after a suitable, UK based, replacement PSU for a 60W Greyfin.
I’m getting a static discharge as the laser is 1st fired in low temperatures (<15C, air temp, not water). I’ve taken the PSU apart and can see no obvious burn damage, but while firing the machine with the PSU cover off I can see the flash. I can still cut at low temps as the arc is not there for long enough to interrupt at the start of the cut. But if engraving fine detail, thin parts are missing. All this stops once air temperature rises!
Can anyone recommend a UK based replacement PSU?
Can you email me at firstname.lastname@example.org thanks.
Sent a message so that you can see my address.